 |
|
In response, buy cleaning system to be cleaned before the following application analysis: a
The material is clear, structure and quantity,
Analysis and clear to remove the dirt,
Decide to use clean water cleaning method, application, or to make cleaning solvent experiment.
Only in this way can we provide appropriate cleaning system, reasonable design of cleaning process and cleaning.
Cleaning choices
Considering the physical characteristics of ultrasonic cleaning, cleaning effect of steam pressure, surface tension, viscosity and density should be the most significant factors. wen
These factors can influence, so it will also affect the efficiency of cavitation.
Any cleaning system must use cleaning. Water system is usually open, workpiece submerged among slot. And the system will be more complex and tank
Equipped with circulation-filtering system, drench trough, drying tank and other accessories.
To use the system, solvent, ultrasonic cleaning XiangChu steam, often equipped with grease for recycling waste. Remove oil vapor phase ultrasonic process is
Ultrasonic extraction solvent evaporation tank and wash tank integrated system of the slot. In the hot vapor and ultrasonic brainstorming, oil, grease, wax
And the other is the dirt in solvent has been removed. After a series of cleaning process under the workpiece material after fever, clean, dry.
When the choice, should consider the following cleaning three factors:
Cleaning efficiency: choose the most effective cleaning solvent, must make experiments. As in the existing in the process of ultrasonic cleaning, introduced by use of solvents
A don't change,
Simple operation, use liquid should non-toxic, simple operation and long life.
Cost: the most cheap cost of cleaning solvent is not certain minimum. Use must consider solvents washing efficiency, safety, and the amount
How can the solvent wash etc. The highest efficiency workpiece, Of course, the choice of cleaning solvent must achieve cleaning effect, and should and cleaning
The workpiece material compatibility. Water is the most common type of using aqueous solution, easy operation, use system of low cost, wide application. However to
In some materials and bilge water solution is not suitable for such as solvent, there are many alternative.
Washing pieces processing
Ultrasonic cleaning is another factor of cleaning, cleaning materials or placed under the tooling design. Washing pieces in ultrasonic cleaning trough,
Whatever cleaning or washing pieces are not touch groove bottom basket. Wash a general cross-sectional area should not exceed ultrasonic slot cross-sectional area of 70 percent. Rubber and not just
Ultrasonic energy absorption of plastic, such materials should be careful for tooling. Insulation cleaning parts also should pay special attention to the cause. Tooling basket improper design
He too, or even the best piece of ultrasonic cleaning system efficiency will be greatly reduced. Any material, if mesh above 50 eyes, for ultrasound
Wave will show the entity, ultrasonic reflecting back to performance. When the mesh 6mm than for ultrasonic shows open the properties of materials. Hook,
Shelves and all available to support the cleaning vessel.
 |
 |
 |
 |
 |